Starre abschleppstange MECANIT 69572180

(344)

Bewertung schreiben

Mehr

€ 27.99

In den Warenkorb

Menge

Auf Lager

Beschreibung

These gages directly measure the diameter of chamfered holes. No setting master is necessary. When the three-blade plunger is pressed against a fl at surface, the gage should read the set number stamped on the back of the indicator. In case of wear, the gage may be adjusted to read the proper number. 0-1 Range In case of wear, the gage may be adjusted to read the proper number.

Starrett 683-3Z Internal Chamfer Gage

Starrett Shaft Alignment Chain Clamp Set with Case

Self-adjusting on cross-sections in the range 0.08 mm2 to 16 mm2 without blade change. No additional tools are required to change the knife block. The

Rennsteig 707 040 MultiStrip Stripper (Adjustable Wire Stripping 0.08 – 16 mm2, Length 195 mm, Blade Change Toolless), Abisolierzange

Maßstab 1:18.

NEW - towing rod passenger car, 3 pieces, for car. Workshop, model building, sca

HHS-M2 HardnessHRC.68 M2(W6Mo5Cr4V2 High-speed steel) is the standard and most widely used industrial HSS. It has small and evenly distributed carbides giving high wear resistance, although its decarburization sensitivity is a little bit high. After heat treatment, its hardness is the same as T1, but its bending Strength can reach 4700 MPa, and its toughness and thermo-plasticity are higher than T1 by 50%.